Technical Notes - JS1 Revelation

TN Nr Rev Issue Date Title Reason
2
2011/04/07
Wingside Autocoupler Replacement
Wingside Autocoupler Replacement
3
2011/07/22
Lift Bush
Lift Bush Re-installment
3
2011/07/22
Centralise Stick
Centralise Stick
1
2011/09/06
Wing Water valve seat
1
2012/01/27
Landing gear travel adjustment
Wheel doors not closing fully
2
2013/04/15
Replacement of water system wing root bush
Improved sealing of water between the wing main rib and torsion tube.
1
2012/04/04
Retrofit of Parachute static line
Retrofit of Parachute static line
1
2012/06/01
JS1 U606 Performance Upgrade Package
WGC 2012
1
2012/07/06
Replacement of Rudder Control Cables
Refer to SB.JS-007 Latest version
1
2012/07/06
Rudder Pedal Replacement
Reducing of rudder control cable wear in S-tubes
1
2012/07/06
Rudder Pedal Main tube & Locking Lever Replacement
The rudder pedal main tube and locking lever design has been refined.
1
2012/12/12
Trailer Modification for 21m Wing Tips
Modification of the trailer to accommodate both the 18 m & 21 m tips.
1
2013/01/14
Replacement of High Pressure Wheel Brake Hose
Replacement and rerouting of the high pressure brake hose in the wheel box.
1
2013/04/12
Calliper Anchor plate
Difficult to Replace JS1 main wheel
1
2014/12/03
Water system pressure relief system installation
The pressure vent system of the main water ballast has been revised.
1
2014/09/03
Jet Sustainer Installation
The Jet Sustainer System was designed to be retrofitted in JS1B, JS1C gliders with the provision for jet available.
3
2014/05/05
Check correct operation of 21m tips water system.
Applicable if required by SB.JS-015.
1
2014/06/11
B2 Cover Plate Installation
Retrofit Installation by Customer
1
2015/02/17
Canopy Frame Damage Repair
Canopy Frame Damaged by Latch Hinge Bolt
1
2015/02/17
Landing Gear Lever and Locking Plate Adjustment
Landing Gear Lever too close to side channel upholstry and adjusting locking plate for secure locking of landing gear
1
2015/02/17
Landing Gear Shock Assembly Bottom Cap
Release/loosen Shock Assembly Bottom Cap
1
2015/02/17
Tailplane Captive Bolt O-Ring Installation
Secure Captive Bolt to not being lost/misplaced.
1
2015/02/13
Fitting of EVO replacement tip to JS1-C inboard wing
Each tip must be integrated to the main wing to ensure adequate fit
1
2015/02/17
21m Wing Tip Drain Plug Installation
This Technical Note sets out the installation procedure to install drain plugs on the 21m wing tips to provide a way to drain the wing tips completely.
1
2015/02/17
Water Tank Sloshing Procedure
This Technical Note describes the procedure to seal the water tanks of the inboard wings, 21m tip wings and the fin.
1
2015/03/11
Installation/replacement of JS1 flaperon driver plates.
This Technical Note describes the process of replacing damaged flaperon driver plates or the installation of optional flaperon driver plates between Flap 1 and Flap 2. wings and the fin.
1
2015/03/26
Elevator Auto Coupler Flange Repair
The Elevator Auto Coupler’s flange may be damaged during assembly or transport. This Technical Note sets out the procedure to repair a crack in this elevator driver flange.